How do I wind my clock?

Floor Clocks with Cables and Pulleys – Weights that are suspended by cables with pulleys should be raised by using the crank provided. DO NOT lift the weights by hand while cranking. Insert the crank into the holes located in the dial face. It does not matter in what order the clock weights wound. All weights need to be wound to the up position.

Floor Clocks with Chains – Pull straight down on the chains. DO NOT lift up on the weights as this could cause the weight to come unhooked from the chain. Pull down on the loose end of the chain until the weight is approximately 2 inches from the bottom of the wood movement mounting board. It does not matter in what order the clock weights wound. All weights need to be wound to the up position.

Wall and Mantel Clocks – Insert the winding key into the holes located in the dial face. Depending upon the model of your clock, there can be 1, 2, or 3 winding keyholes. Turn the key clockwise until the spring becomes tight and will not turn further. For clocks with hanging weights, raise the weights using the crank. DO NOT lift the weights by hand while cranking. Wind your clock once a week. It does not matter in what order the clock weights wound. All springs must be fully wound.